This is an old revision of the document!
Table of Contents
TLDR: driver here: https://github.com/JohnDMcMaster/uvscada/tree/master/gxs700
Bare sensors
Some of these were sold at defcon 22. Look something like this:
WARNING WARNING WARNING
Bond wires are exposed! Be very very careful handing these! Seen at upper part of sensor above
WARNING WARNING WARNING
JM 2015-11-24: gave away my possibly working bare sensors (3x) and kept 2x definitely broken. Still have 2x encased units
PCB
USB pinout
I didn't pin it out when I had the chance but have a picture:
Flash
“128 Megabit CMOS 3.0 Volt Flash Memory with 104-MHz SPI (Serial Peripheral Interface) Bus”
SPANSION FL128PIF 12699003 C THAILAND (C) 06
FPGA
Sticker:
001- 00015
Package:
Actel ProASIC3 A3P250 QNG132 1140 ZA637115
FX2 USB controller
“CY7C68 Series 16 kb RAM EZ-USB FX2LP USB Microcontroller”
CY7C68 13A4S65 1131 642364
MT unknown
9WA47 PW6B7 01Z9 MT
274
274 036 .VY
USB connector
5 pin ribbon cable
- 1: +5V
- 2: GND
- 3: D+
- 4: D-
- 5: N/C?
- Goes to unpopulated capacitor or something
Die
No maker's mark observed on die. There are some foundry marks but that probably won't be very helpful even if the foundry is identified
CNC machine
DIY XY scanner