mcmaster:lapping
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| mcmaster:lapping [2015/09/26 21:28] – mcmaster | mcmaster:lapping [2015/09/26 21:39] (current) – mcmaster | ||
|---|---|---|---|
| Line 59: | Line 59: | ||
| * Lapping stencil target diameter: 54 mm | * Lapping stencil target diameter: 54 mm | ||
| * Add 1.5 mm to each side w/ 1.5 mm clearance | * Add 1.5 mm to each side w/ 1.5 mm clearance | ||
| + | * Support at least entire cavity size + 1/8" endmill => 57.1 + 1/8 * 25.4 = 60.3 mm | ||
| + | * Add some good clearance so I don't mill the jig: 5 mm each side => 70 mm total ID => 2.75" | ||
| + | * 0.5" each side => 3.75" Al square stock | ||
| + | * 1.5" from sherline t-slot to slot | ||
| + | * 10-32 (0.1900" | ||
mcmaster/lapping.1443302896.txt.gz · Last modified: 2015/09/26 21:28 by mcmaster