This shows you the differences between two versions of the page.
Previous revision | |||
— | test_pattern [2018/12/02 20:10] (current) – [References] mcmaster | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | Work in progress: aims to identify the purpose of various wafer test patterns, process control monitors (PCM), alignment markers, etc. | ||
+ | |||
+ | ====== Alignment ====== | ||
+ | |||
+ | {{gallery> | ||
+ | |||
+ | Pass condition: concentric | ||
+ | |||
+ | Used to align mask/ | ||
+ | |||
+ | ====== Continuity ====== | ||
+ | |||
+ | Pass condition: low resistance. | ||
+ | |||
+ | A long wire that should maintain a good electrical signal. | ||
+ | |||
+ | ====== Isolation ====== | ||
+ | |||
+ | Pass condition: high resistance | ||
+ | |||
+ | Two wires placed close to each other that should not short. | ||
+ | |||
+ | ====== Chain (contact, via) ====== | ||
+ | |||
+ | {{gallery> | ||
+ | |||
+ | {{gallery> | ||
+ | |||
+ | {{gallery> | ||
+ | |||
+ | {{gallery> | ||
+ | |||
+ | Pass condition: low resistance | ||
+ | |||
+ | ====== Contact resistance ====== | ||
+ | |||
+ | Four point probe. Two | ||
+ | |||
+ | ====== References ====== | ||
+ | * [[http:// | ||
+ | * [[https:// | ||
+ | * http:// | ||
+ | |||