This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| technics:hummer [2018/08/20 15:47] – mcmaster | technics:hummer [2018/08/21 06:50] – mcmaster | ||
|---|---|---|---|
| Line 146: | Line 146: | ||
| * ~0.073" | * ~0.073" | ||
| * Bell jar L gasket | * Bell jar L gasket | ||
| + | |||
| + | 2018-08-20 | ||
| + | * Install banana plug to ground pedestal | ||
| + | * Order cap to attach to pedestal | ||
| + | * Shaft is about 0.37" | ||
| + | * Something like: https:// | ||
| + | * Install metal backing plate into TITE connector | ||
| + | * Much stiffer now | ||
| + | * Scratching post a little...don' | ||
| + | * Didn't grease o-ring or post. Maybe should have? | ||
| + | * Was able to sputter coat a sample! | ||
| + | * First time in several years | ||
| + | |||
| ====== mcmaster Hummer VI ====== | ====== mcmaster Hummer VI ====== | ||
| Line 280: | Line 293: | ||
| * 3 wk LT | * 3 wk LT | ||
| * Summary: a lot of sleuthing, but around $100 to fully replace a chamber | * Summary: a lot of sleuthing, but around $100 to fully replace a chamber | ||
| + | |||
| + | |||