This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
| ks:4124 [2018/04/26 05:33] – [PCB] mcmaster | ks:4124 [2018/04/30 04:53] – mcmaster | ||
|---|---|---|---|
| Line 50: | Line 50: | ||
| 1 mil wire => 30-30 mils below capillary | 1 mil wire => 30-30 mils below capillary | ||
| Greater gap => smaller wire | Greater gap => smaller wire | ||
| + | To adjust: loosen knurled knob | ||
| EFO horizontal | EFO horizontal | ||
| 4 mm to left of capillary tip | 4 mm to left of capillary tip | ||
| Loosen solenoid clamping screw | Loosen solenoid clamping screw | ||
| + | SHCS allen key: 77 mil | ||
| EFO overtravel | EFO overtravel | ||
| 50-60 mil beyond capillary tip | 50-60 mil beyond capillary tip | ||
| Loosen solenoid ring set screws | Loosen solenoid ring set screws | ||
| + | SS allen key: 34 mil | ||
| + | Capillary adjustment | ||
| + | SHCS allen key: ? couldn' | ||
| + | diameter: 1.47 mm | ||
| + | thread: 1.25 / 4 = 0.3125 mm | ||
| + | Capillary diameter: 1/16" | ||
| + | Allen key inserted for alignment: 56 mil | ||
| + | 63 mil diagonol vs 1/16" => 63 mil | ||
| Wire loading | Wire loading | ||
| 6.1.10 | 6.1.10 | ||
| First o-ring 3/8" from flared side of funnel | First o-ring 3/8" from flared side of funnel | ||
| </ | </ | ||
| + | |||
| + | 150C workholder | ||
| ====== Connectors ====== | ====== Connectors ====== | ||