This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| decap:epoxy [2020/02/27 20:58] – [McMaster live 2019-11-10] mcmaster | decap:epoxy [2020/02/27 21:02] – [McMaster live 2019-11-10] mcmaster | ||
|---|---|---|---|
| Line 135: | Line 135: | ||
| ===== McMaster live 2019-11-10 ===== | ===== McMaster live 2019-11-10 ===== | ||
| - | {{: | + | {{: |
| Experiments trying to decap COB while keeping PCB intact | Experiments trying to decap COB while keeping PCB intact | ||
| + | |||
| TLDR best result | TLDR best result | ||
| Line 150: | Line 151: | ||
| Above is a compromise between PP providing the best chemical resistance and silicone providing the best seal | Above is a compromise between PP providing the best chemical resistance and silicone providing the best seal | ||
| + | |||
| + | {{: | ||
| + | |||
| + | Above: hardened silicone bubbles on WFNA surface | ||
| Silicone only experiment | Silicone only experiment | ||
| Line 162: | Line 167: | ||
| Someone also suggested I should try PTFE gasket. In the past I had tried kapton which didn't work well (acid tended to wick into kapton). Maybe PTFE would repel acid better | Someone also suggested I should try PTFE gasket. In the past I had tried kapton which didn't work well (acid tended to wick into kapton). Maybe PTFE would repel acid better | ||
| + | Reference: https:// | ||
| ====== Live analysis considerations ====== | ====== Live analysis considerations ====== | ||