| Both sides previous revisionPrevious revisionNext revision | Previous revision |
| chemical:hno3:distillation [2012/08/25 19:50] – [Procedure] mcmaster | chemical:hno3:distillation [2018/09/05 17:00] (current) – [References] mcmaster |
|---|
| {{:chemical:hno3:distillation:healthy_bubbles.jpg?300|}} | {{:chemical:hno3:distillation:healthy_bubbles.jpg?300|}} |
| |
| Once it gets hot enough the KNO3 will completely dissolve in the H2SO4. It should give a healthy bubble like above. Try not to let the level exceed halfway. | Once it gets hot enough the KNO3 will completely dissolve in the H2SO4. It should give a healthy bubble like above. Try not to let the level exceed halfway. Its fine if the mixture is only bubbling at top and is liquid at bottom (ie just at the boiling point). |
| |
| This works okay but takes a while to heat up (30-45 minutes typical IIRC). Helped a little to put aluminum foil over the still. Overall, the probably was that the Vireux condenser was overkill for the level of purity I require. | This works okay but takes a while to heat up (30-45 minutes typical IIRC). Helped a little to put aluminum foil over the still. Overall, the probably was that the Vireux condenser was overkill for the level of purity I require. |
| * If more than a few mL of acid accumulates in the vacuum trap decrease flow rate or cool collection flask more | * If more than a few mL of acid accumulates in the vacuum trap decrease flow rate or cool collection flask more |
| * Might be able to put fiberglass or similar in the vacuum trap to help it condense / increase surface area | * Might be able to put fiberglass or similar in the vacuum trap to help it condense / increase surface area |
| | * Once solution is dissolved / under vacuum do not let it solidify on the surface (its fine if its bubbling on top and slushy under). If you do it will form an insoluble layer that will considerably slow down distillation. Try to rapidly drop pressure (rapidly increase vacuum), in some situations this can shatter it and bring back normal distillation. Thus, if the solution level is getting too high favor decreasing pressure and increasing temperature over simply decreasing vacuum |
| |
| |
| Don't try to pour old the hot H2SO4 / KNO3 biproduct (KHSO4). It will likely solidify on the cooler upper half of the flask and close it off. This can cause pressure to build from the still hot bottom cooking off. Instead, wait until its cool and then add water. It will likely take a number of washings to get it all out. Warm water and sloshing it around so that it breaks up and not just dissolves helps. I blow the flask with a fan to help it cool down faster. The more acid you use the more acid that will be leftover and keeping the mixture liquid. Above: KHSO4 waste product. | Don't try to pour old the hot H2SO4 / KNO3 biproduct (KHSO4). It will likely solidify on the cooler upper half of the flask and close it off. This can cause pressure to build from the still hot bottom cooking off. Instead, wait until its cool and then add water. It will likely take a number of washings to get it all out. Warm water and sloshing it around so that it breaks up and not just dissolves helps. I blow the flask with a fan to help it cool down faster. The more acid you use the more acid that will be leftover and keeping the mixture liquid. Above: KHSO4 waste product. |
| |
| | ====== References ====== |
| | |
| | http://www.sciencemadness.org/talk/viewthread.php?tid=13090&page=2 |
| | * Persulfate to reduce NO2 |
| |
