mcmaster:pb_brick
Differences
This shows you the differences between two versions of the page.
| mcmaster:pb_brick [2015/09/10 05:14] – created mcmaster | mcmaster:pb_brick [2015/09/10 05:19] (current) – mcmaster | ||
|---|---|---|---|
| Line 18: | Line 18: | ||
| Fill hole sized experimentally after original hole seized up too easily | Fill hole sized experimentally after original hole seized up too easily | ||
| + | |||
| + | Only made one mold. It warped after a few bricks due to difficulty cleaning it to make good seals | ||
| + | |||
| + | |||
| + | ====== Iron production ====== | ||
| + | |||
| + | Make 4 molds to ease cooling and other production | ||
| + | |||
| + | Experiment with fluxing sides to make lead not stick | ||
| + | |||
| + | Plan to semi-automate based on diagram: MDI / hand written g-code. | ||
| + | |||
| + | Reduce mold slats to minimum size? Not sure how beneficial the extra was | ||
| + | * Think its main advantage was easy of machining: easier to grab | ||
| + | * Consider reducing slightly but not to min size | ||
| + | * Min: 6 + 2 * 0.125 = 6.25 | ||
| + | * Cut to 7" to leave slightly over 0.5" each side to grip | ||
| + | |||
mcmaster/pb_brick.1441862070.txt.gz · Last modified: 2015/09/10 05:14 by mcmaster