Differences

This shows you the differences between two versions of the page.

--- klinger:ut100 [2018/08/20 06:18] – mcmaster
+++ klinger:ut100 [2018/08/25 00:52] (current) – mcmaster
@@ Line 11: / Line 11: @@
   * 2x UE72/50mm: on order
   * 2x UE30/50mm: drop in pr0nscope replacement
+====== Bolt pattern ======
+M4 screws
+For some reason the counter-bored holes at the base are tapped. I drilled them out to make an M4 bolt slide through
+  * #14 (0.182") drill to match existing holes
+  * Note M4 diameter: 4 mm => 0.157"
+There are feedthroughs that probably allow unbolting a lower stage without unbolting the upper stage (ie remove XY stage from a baseplate)
+Looks to be 63 mm bolt spacing
+Looks like you need at least 0.15" clearance from bolt shoulder to top. I observed that 0.155 bolts were getting scraped, 0.150 seemed fine. To be safe, I turned bolt tops down to < 0.13. This was done by holding bolts in a drill while using a Dremel cutting wheel to sand them down.
@@ Line 22: / Line 36: @@
 Official controller is CC-1, which can handle UE72 and UE30
+===== UE30 =====
+{{mcmaster:klinger:ut100:gear1.jpg?300}}
+{{mcmaster:klinger:ut100:gear2.jpg?300}}
+{{mcmaster:klinger:ut100:gear3.jpg?300}}
+Above: UE30 gearbox
 ===== UE30 encoder stepper retrofit =====
+{{mcmaster:klinger:ut100:encoder_conversion.jpg?300}}
+Above: removing encoder. Middle picture shows encoder disk holder, although encoder disk has fallen off
 pr0nscope attached an MDrive17 stepper to the encoder by doing the following:
@@ Line 44: / Line 70: @@
 ====== Stage ======
+{{mcmaster:klinger:ut100:in1.jpg?300}}
+Above: stage open ,showing a sheared coupler
 If you crash the axis, an internal shaft coupler may shear (oops). TODO: figure out replacement part number
@@ Line 55: / Line 85: @@
 ====== Connector ======
+{{mcmaster:klinger:ut100:improvised_connector.jpg?300}}
+Above: improvised connector
 {{:klinger:ut100:jaeger19.png?600|}}
@@ Line 64: / Line 98: @@
   * I'm making same cables
   * Stepper wire: Molex 1552200235 (16 AWG, multi-conductor, 5 conductor)
+====== Assembly ======
+To remove the shaft coupler: remove the set screw at the bottom of the stage. Then rotate shaft until the second set screw lines up with the just opened hole
 ====== mcmaster ======