decap:ceramic
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| decap:ceramic [2019/12/17 03:05] – Mu mcmaster | decap:ceramic [2025/08/04 21:23] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 25: | Line 25: | ||
| ====== Glass frit ====== | ====== Glass frit ====== | ||
| + | |||
| + | 2020-10-21 | ||
| + | * General consensus may be that heating to below melting point (softens but doesn' | ||
| + | * Mind heat and cool cycles to avoid thermal shock | ||
| JM 2016-11 advice: | JM 2016-11 advice: | ||
| Line 91: | Line 95: | ||
| ===== Bandsaw ===== | ===== Bandsaw ===== | ||
| + | |||
| + | {{: | ||
| + | |||
| + | Above: fixturing for cutting. Sample held in DIP 40 ZIF. Use cross slide to stablize. | ||
| {{: | {{: | ||
| Line 110: | Line 118: | ||
| * Saw a slit on both sides of the cavity | * Saw a slit on both sides of the cavity | ||
| * As far as possible, usually about 0.1" after the quartz window | * As far as possible, usually about 0.1" after the quartz window | ||
| + | * Saw just into the glass frit | ||
| + | * WARNING: failing to completely separate ceramic can lead to unpredictable breakage | ||
| * Should be roughly above where the bond wires attach but not above the die | * Should be roughly above where the bond wires attach but not above the die | ||
| * Small debris in the cavity is normal and shouldn' | * Small debris in the cavity is normal and shouldn' | ||
| Line 125: | Line 135: | ||
| Grinding: | Grinding: | ||
| + | * Grinding was used more initially, but can be slower (especially for large packages) and may have increased change to damage die | ||
| + | * Alternate side of blade used to prolong blade life | ||
| * Slowly side grind and/or cut across the whole cavity | * Slowly side grind and/or cut across the whole cavity | ||
| * Cut about halfway through the top ceramic | * Cut about halfway through the top ceramic | ||
| Line 130: | Line 142: | ||
| * Try to make one continuous cut | * Try to make one continuous cut | ||
| * Multiple cuts increase change to fragment and create larger debris | * Multiple cuts increase change to fragment and create larger debris | ||
| + | * Wash nail polish away with acetone | ||
| + | * See UV masking page for more info | ||
| ===== Thermal fracture (old) ===== | ===== Thermal fracture (old) ===== | ||
decap/ceramic.1576551924.txt.gz · Last modified: 2019/12/17 03:05 by mcmaster