EG&G/ORTEC AN308/NL DUAL 8-INPUT MIXER.

CHARACTERISTICS
The AN308/NL is a direct-coupled dual 8-input linear mixer capable of high-speed summing of either anode or dynode signals from a fast photomultiplier array. The unit is packaged in a single-width NIM module (per TID-20893) for installation in a NIM-standard bin and power supply. Each of the two identical sections of the unit can accept the signals from up to eight sources provided that the sum of their simultaneous signals does not exceed 2V of either polarity on 50 Ohm.  With a nominal gain of unity the summed signals are fanned out through a bridging 2-connector output to be terminated in 50 Ohm. For larger systems the two sections of the AN308/NL can be connected to serve as one 16-input linear mixer. The wide dynamic range of the unit allows its outputs to be used for large majority logic functions.  The inputs of the AN308/NL provide good 50 Ohm termination with low reflections from fast transient signals.  A high degree of input protection is provided to accommodate large overloads without damage.  The output is noninverting, and for fast rising input signals the output rise-time limits at 2 nSec with minimum overshoot and distortion.  The unit is completely dc-coupled and its input and output offsets are sufficiently stable for several sections to be cascaded.

SPECIFICATIONS

INPUTS

Inputs 1 - 8

LEMO Connectors accept input signals

Impedance

50 Ohm dc-coupled

Polarity

Positive or negative

Reflections

<5% for +/-2V, 1 nSec rise-time input

Linear Range

+2V to -2V

Protection

+/-5V dc, +/-50V transient

Offset

<+/-5 mV with all inputs terminated in 50 Ohm

Temperature Coefficient

<100 uV/'C

OUTPUTS

Out

Two LEMO connectors for fanout of one bridging current source per section

Polarity

Noninverted input polarity

Linear Range

+40mA to -40mA

 

Offset

Adjustable from +150mV to -150mV on 50 Ohm load

Temperature Coefficient

<300uV/'C on 50 Ohm load

Rise and Fall Times

<2nSec with all inputs terminated in 50 Ohm

Overshoot

<5% with all inputs terminated in 50 Ohm

CONTROLS

DC Balance

Front panel 22-turn potentiometer controls the output offset

PERFORMANCE

Gain

0.91 +/- 1.5% over full linear range with all inputs and outputs terminated in 50 Ohm

Bandwidth

> 180 MHz

Propagation Delay

Typ. 2.5 nSec

Operating Temp. Range

0-50'C

ELEC. & MECH.

Dimensions

Single-width NIM-standard module

Connectors

LEMO 00C50

Power Required

  +6V     90mA;    -6V   88mA 
+12V  130mA;  -12V  130mA 
+24V  0mA;     -24V     0mA


Up to a higher level directory  | |  For more information