VOLTAGE CONTROL	±3.5 kV Configuration	±7 kV Configuration
Range	100-3500 V	200-7000 V
CAMAC Programming	14 bits	14 bits
CAMAC Step	0.25 V	0.5 V
CAMAC Accuracy	² ±(1.5 V + 0.1%)	² ±(3 V + 0.1%)
Front-Panel Adjustment	Ten-turn vernier potentiometer
	500 V/turn	1000 V/turn
CAMAC Monitor	12-bit ADC	12-bit ADC
CAMAC Resolution	1 V	2 V
CAMAC Offset (response to 0 V output)	0-2 counts	0-2 counts
CAMAC Accuracy	±0.2%	±0.2%
Front-Panel Monitor	Low Impedance (< 10 ohm) voltage output, suitable for driving a meter; BNC connector.
Front-Panel Scale	2 V/kV ±0.5%	1 V/kV ±0.5%
Front-Panel Offset (value for 0 V output)	² ±4 V referred to HV output	² ±8 V referred to HV output
CURRENT CONTROL
Range	0-2.5 mA	0-1 mA
CAMAC Programming	8 bits	8 bits
CAMAC Step	10 µA	4 µA
CAMAC Accuracy	±(1% + 12 µA)	±(1% + 5 µA)
Front-Panel Adjustment	Ten-turn vernier potentiometer
	250 µA/turn	100 µA/turn
CAMAC Monitor	12-bit ADC	12-bit ADC
CAMAC Resolution	625 nA	250 nA
CAMAC Offset (Response to 0 µA load)	1 or 2 counts	1 or 2 counts
CAMAC Accuracy	±0.5%	±0.5%
Front-Panel Monitor	Low Impedance (< 10 ohm) voltage output, suitable for driving a meter; BNC connector.
Front-Panel Scale	4 V/mA ±0.5%	10 V/mA ±0.5%
Front-Panel Offset (value for 0 V output)	² ±4 µA	² ±2 µA
GENERAL
Output Power Rating	7 W	7 W
Output Ripple (at maximum current)	< 50 mV rms	< 50 mV rms
Output Temperature Coefficient	Typically ±50 ppm/¡C, ±100 ppm/¡C maximum
Voltage Regulation	< 0.5 V (0 to 2.5 mA)	< 1 V (0 to 1 mA)
Short Circuit Protection	Yes	Yes
Output Connector	SHV	Reynolds 1064-1
CONTROLS
HV On/Off	Toggle switch; turns On/Off HV output.
Manual/Remote	Selects front panel or CAMAC operation of voltage and current set.
ADC	12 bits; conversion time < 30 µsec.
INDICATOR LAMPS
HV On	Voltage present at output.
Overload	Supply in current-limiting mode.
Positive	Positive output configuration.
Negative	Negative output configuration.
3.5 kV	ON	OFF
7 kV	OFF	ON
POWER	350 mA at +24 V; 350 mA at -24 V; 350 mA at +6 V.