tech:start
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| tech:start [2015/05/13 14:45] – azonenberg | tech:start [2025/11/18 05:31] (current) – [Table] azonenberg | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | The intention of this table is to allow easy identification of a | + | The intention of this table is to allow rough identification of a device' |
| - | This list includes ITRS standard nodes only, tag devices at the nearest appropriate node. | + | This list includes ITRS standard nodes only, tag devices at the nearest appropriate |
| - | Please only tag devices whose process geometry is known for certain; this will allow us to more easily compare examples of devices at each node. | + | Devices ≤ 90nm typically have thick top metal with a much larger design rule. There do not appear to be significant scaling trends in top metal pitch below 90nm, |
| - | ^Node ^Vcore ^Layer count ^Mz pitch ^M1 pitch ^SRAM pitch ^References | | + | There are two Vcore columns. The typical numbers are the nominal operating voltages for standard process, the minimum numbers are the lowest voltages allowed for low-power versions of the process. |
| - | |[[: | + | |
| - | |[[: | + | Typically devices >180 nm are entirely Al metallization, |
| - | |[[: | + | |
| - | |[[: | + | ^ Node ^ Vcore (min) ^ Vcore(typ) |
| - | |[[: | + | | [[: |
| - | |[[: | + | | [[: |
| - | |[[: | + | | [[: |
| - | |[[: | + | | [[: |
| - | |[[: | + | | [[: |
| - | |[[: | + | | [[: |
| - | |[[: | + | | [[: |
| - | |[[: | + | | [[: |
| - | |[[: | + | | [[: |
| - | |[[: | + | | [[: |
| - | |[[: | + | | [[: |
| - | |[[: | + | | [[: |
| - | |[[: | + | | [[: |
| - | |[[: | + | | [[: |
| + | | [[: | ||
| + | | [[: | ||
| + | | [[: | ||
| + | | [[: | ||
| \\ | \\ | ||
tech/start.1431528302.txt.gz · Last modified: 2015/05/13 14:45 by azonenberg
