Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
recap [2016/12/23 18:57] mcmasterrecap [2016/12/23 18:58] (current) mcmaster
Line 2: Line 2:
  
 Some options: Some options:
-  * Tape over cavity: current standard practice.  Use Kapton +  * Tape over cavity: current standard practice.  Use Kapton.  When wrapped fully around is very strong 
-  * Slide coverglass glued to top: probably a good long term solution+  * Slide coverglass glued to top: probably a good long term solution.  CA glue allows later removal
   * Nail polish: dries slowly.  Would need to be applied in thin layers.  Otherwise, think its pretty inert?   * Nail polish: dries slowly.  Would need to be applied in thin layers.  Otherwise, think its pretty inert?
   * Hot glue: CTE might destroy bond wires   * Hot glue: CTE might destroy bond wires
  
 
recap.txt · Last modified: 2016/12/23 18:58 by mcmaster
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution 4.0 International
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki