This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
decap:epoxy [2018/02/28 06:55] – [A. Zonenberg etch rate measurement] mcmaster | decap:epoxy [2019/05/13 21:00] – [Light Ray] mcmaster | ||
---|---|---|---|
Line 222: | Line 222: | ||
* They do the whole chip but avoid die area | * They do the whole chip but avoid die area | ||
* Light Ray - IC Decapsulation | * Light Ray - IC Decapsulation | ||
+ | |||
+ | |||
+ | ===== mcmaster ezlaze ===== | ||
+ | |||
+ | TODO: add pictures, estimate material removal rate | ||
+ | |||
+ | Basically this was too slow to be practical except for very small samples. That said, it did work very well. A quicklase or other higher throughput Nd:YAG system would likely work well | ||
====== Sandblast ====== | ====== Sandblast ====== |