[[mcmaster:start]]
 
Trace:

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
mcmaster:start [2022/07/08 17:11]
mcmaster 		mcmaster:start [2023/02/16 10:17] (current)
Line 73: Line 73:
 In general I want to focus on R&D / labwork and not hand digitization.  I do have some limited semi-automatic digitization capabilities for planarized chips though that I'd like to develop (ex: works on PS1 chipset). In general I want to focus on R&D / labwork and not hand digitization.  I do have some limited semi-automatic digitization capabilities for planarized chips though that I'd like to develop (ex: works on PS1 chipset).
  
-Most of this is targeted towards small chips up to the mid 90's.  If the die is obnoxiously large (ex: 486 CPU) it will be difficult for me to photograph and stitch the entire thing.  Similarly most of my equipment is targeted towards larger processes (say 180+nm), although I do have a small SEM if required. See [[https://siliconpr0n.org/map/xilinx/xc2c32a/lap4-04_mit20x/|XC2C32A]] for an example 180 nm chip taken with a relatively low power objective, noting in theory I can get about 11x the detail (NA 0.42 => 1.4).+Most of this is targeted towards small chips up to the mid 90's.  If the die is obnoxiously large (ex: 486 CPU) it will be difficult for me to photograph and stitch the entire thing.  Similarly most of my equipment is targeted towards larger processes (say 180+nm), although I do have a small SEM if required. See [[https://siliconpr0n.org/map/xilinx/xc2c32a/mcmaster_lap4-04_mit20x/|XC2C32A]] for an example 180 nm chip taken with a relatively low power objective, noting in theory I can get about 11x the detail (NA 0.42 => 1.4).
  
 Other: most of the work is in decapping, not actual imaging. If you happen to already have a bare, clean die and would be satisfied with a quick / lower quality scan, feel free to send me a few dies. This also can work out well since most of the NRE cost is in the microscope, not the decapping supplies. Other: most of the work is in decapping, not actual imaging. If you happen to already have a bare, clean die and would be satisfied with a quick / lower quality scan, feel free to send me a few dies. This also can work out well since most of the NRE cost is in the microscope, not the decapping supplies.
 
mcmaster/start.1657300292.txt.gz · Last modified: 2022/07/08 17:11 by mcmaster
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution 4.0 International
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki