Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
azonenberg:ti:drv2605 [2013/12/23 01:49]
azonenberg
azonenberg:ti:drv2605 [2015/01/04 17:50] (current)
Line 3: Line 3:
 I2C controlled haptic motor driver packaged in a 3x3 ball 0.5mm WLCSP. I2C controlled haptic motor driver packaged in a 3x3 ball 0.5mm WLCSP.
  
-This chip was removed from a PCB which had been damaged during assembly and would otherwise have been scrapped; there is a small amount of flux residue on the underside as a result. One corner of the die was slightly chipped during removal from the PCB.+This chip was removed from a PCB which had been damaged during assembly and would otherwise have been scrapped; there is a small amount of flux residue on the underside as a result. ​For these quick overview shots, no extensive cleaning was performed. 
 + 
 +One corner of the die was slightly chipped during removal from the PCB.
  
 No decap was required; the top metal layer is visible through the polyimide overcoat simply by looking at the bottom side of the packaged device. No decap was required; the top metal layer is visible through the polyimide overcoat simply by looking at the bottom side of the packaged device.
 
azonenberg/ti/drv2605.txt · Last modified: 2015/01/04 17:50 (external edit)
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution 4.0 International
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki