This shows you the differences between two versions of the page.
azonenberg:ti:drv2605 [2013/12/23 06:49] azonenberg |
azonenberg:ti:drv2605 [2015/01/04 22:50] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | {{tag> | ||
- | I2C controlled haptic motor driver packaged in a 3x3 ball 0.5mm WLCSP. | ||
- | |||
- | This chip was removed from a PCB which had been damaged during assembly and would otherwise have been scrapped; there is a small amount of flux residue on the underside as a result. One corner of the die was slightly chipped during removal from the PCB. | ||
- | |||
- | No decap was required; the top metal layer is visible through the polyimide overcoat simply by looking at the bottom side of the packaged device. | ||
- | |||
- | Author' | ||
- | |||
- | Top metal pitch looks like ~600nm. Maybe 180nm tech? | ||
- | |||
- | ====== Device overview ====== | ||
- | |||
- | Brightfield | ||
- | |||
- | {{: | ||
- | |||
- | Darkfield | ||
- | |||
- | {{: | ||
- | |||
- | ====== Closeups ====== | ||
- | |||
- | {{: | ||
- | |||
- | {{: | ||
- | |||
- | {{: | ||
- | |||
- | {{: | ||
- | |||
- | {{: | ||
- | |||
- | {{: |